ADW系列AIRTAC末端排水器安裝尺寸
浮子杠桿式結構，起排位置低，排水更穩定；
高強度聚碳酸酯水杯，外加鋼質保護罩，使用更安全可靠；
ADW400系列可應用于如下列之空壓設備：儲氣罐、乾燥機、過濾器、管路。
選擇上述空壓設備之低端以（1/2")接頭連接少需有300mm以上的空間。
空壓設備與ADW400入口之間好設一1/2"手動閥以利于日后保養或維修。
空壓設備的排氣量不得低于180L/min（約1馬力空壓機）。
安裝時，排水口應垂直向下，排水管避免上彎。
請勿使用強酸性物質或揮發性油氣類（鹽酸、汽油、甲苯等）擦洗PC集水杯，以免破裂。
拆卸PC集水杯和金屬保護罩時，請先按下本體上的殘壓排放六角螺帽，
確保集水杯內殘壓完全釋放，以確保人身安全。
雙重不銹鋼濾網過濾，保證排水器正常工作；
大口徑入口通路，顆粒、銹渣等雜質不會積存通路死角；
大容量污垢過濾貯水杯，較一般排水器可過濾貯存更多量銹渣和污垢；
大型浮子，浮力強控制靈敏；
大尺寸集水杯，可貯存較多量水份而減少排放次數，延長使用壽命。
ADW系列AIRTAC末端排水器安裝尺寸
Float lever structure, low row position, more stable drainage;
It is necessary to select the space at the lowest end of the above-mentioned air compressor (1/2 ") for at least 300 mm.
Between the air compressor and the ADW400 inlet, it is best to set a 1/2 "manual valve for future maintenance or repair.
The displacement of the air compressor shall not be less than 180 L / min (approx. 1 hp air compressor).
Installation, the drain should be vertical down, drain to avoid bending.
Do not use a strong acid or volatile oil and gas (hydrochloric acid, gasoline, toluene, etc.) scrub the PC set cup, so as not to rupture.
When removing the PC cup and l protective cover, press the residual pressure on the body to release the hex nut,
To ensure that the residual pressure within the cup is completely released to ensure personal safety.
Double stainless steel filter to ensure that the drainage work properly;
Large diameter inlet access, particles, rust and other impurities will not accumulate path dead ends;
Large capacity dirt filter storage cup, more than the general drainage filter can store more amount of rust and dirt;
Large float, buoyant strong control sensitive;
Large size cup, can store a lot of water and reduce the number of emissions, to extend the service life.
ADW系列AIRTAC末端排水器安裝尺寸
